چکیده:
درک مورفودینامیک پیوندگاه رودخانهها بخش مهمی از بررسیهای ژئومورفولوژی رودخانهای است که با وقوع سیل فروردین 1398 شرایط مناسبی فراهم شد تا تغییرات فرسایش و رسوب ناشی از آن در پیوندگاه دو رودخانه دینور به گاماسیاب سنجیده شود. با توجه به پیچیده بودن الگوی جریان و رسوب در این محل و همچنین با افزایش ناگهانی این دو پارامتر، شبیهسازی عددی سه بعدی مقرون به صرفه نیست و مدلهای تک بعدی نیز به دلیل عدم توجه به ماهیت سه بعدی جریان عموماً با خطا همراه هستند. به همین دلیل استفاده از مدلهای دو بعدی در صورت قابل قبول بودن خطای آن میتواند مفید باشد. بنابراین در تحقیق حاضر از مدل SRH-2D برای بررسی تأثیر سیل فروردین 1398 بر ریختشناسی محل تلاقی رودخانه دینور به گاماسیاب استفاده شد . برای بررسی تغییرات مورفولوژی منطقه مورد مطالعه، منطقه مورد مطالعه در دو مرحله قبل و بعد از سیل از نظر توپوگرافی نقشه برداری شد. همچنین جهت بررسی عوامل مؤثر بر ریختسنجی رسوبات بستر رودخانهها و مشخص کردن قطر ذرات رسوب و ضریب زبری بستر آزمایش گرانومتری انجام گرفت. با توجه به اینکه مدل SRH_2D قابلیت شبکهبندی را ندارد، مش مورد نیاز با استفاده از نرم افزار SMS تهیه شد و فایل خروجی مدل با فرمت TECPLOT ذخیره شد. نتایج این تحقیق نشان داد در یک سیلاب با دوره بازگشت 35 ساله پیوندگاه رودخانه دینور به گاماسیاب که با زاویه 40 درجه به صورت مئاندری به داخل مئاندر اصلی وارد می شود، فرسایش بستر در اوایل وقوع سیل در بخش پایین دست پیوندگاه به سبب به وجود آمدن ناحیه جریانات آشفتته آغاز شده و بتدریج به بخش های بالا گسترش مییابد، در حالی که رسوبگذاری کمی بعد از اوج سیلاب در محل رکود اتفاق میافتد و با کاهش سیل باعث گسترش دماغه و در اواخر سیلاب توسعة جانبی قوس خارجی رودخانة گاماسیاب میشود
Understanding the morphodynamics of river junctions is an important part of fluvial geomorphological studies that were provided suitable conditions to measure erosion and sediment changes at the junction of Dinver and Gamasiab rivers by the occurrence of floods in April 2017. Due to the complexity, 3D numerical simulation is not cost-effective, and one-dimensional models, also, have some errors. For this reason, the use of two-dimensional models can be useful. Therefore, the SRH-2D model was used to investigate the effect of the flood on the morphology of the confluence of the Dinver River to Gamasiab. To study the morphological changes in the study area, elevation position and topography was mapped in two stages before and after the flood and also a granulometric experiment was performed. Due to the fact that the SRH_2D model does not have the ability to network, the required mesh was prepared using SMS software and the output file of the model was saved in TECPLOT format. The results showed that in a flood with a 35-year return period of the Dinver River to Gamasiab junction, with a meander- meander junction at a 40-degree angle, bed erosion in the downstream part of the junction begins to occur early in the onset of flooding and gradually expands to the upstream. However, sedimentation occurs shortly after the peak of the flood in the stagnation zone and then growing the spurs as the flood decreases, and developing the outer arch of the Gamasiab River as at the flood goes to end.