چکیده:
The foot is one of the most important limbs of the body and the main interface for the reciprocal activity of the body with the ground. Any changes in the structure of the foot caused by various diseases may lead to changes in the pressure distribution function in the foot. Medical insoles are widely used to treat various ailments of the foot and ankle. In most cases, medical insoles are used to create proper pressure distribution on the sole of the foot. The aim of this study is to simulate the foot as well as design and optimize a medical insole in terms of shape and material. To this end, a model of a diabetic person's foot was prepared using CT scan images. Then, the initial insole was designed in 3D design software and assembled in finite element analysis software. The model obtained from the CT scan images was also imported into the analytical software with the addition of ligaments. All boundary conditions and loads were applied to the final model. The pressures applied to the sole and the insole were calculated by performing finite element analysis, and by establishing a relationship between the pressures applied to the insole and the coordinates-insole materials, the optimization of the insole's shape and material was performed. The results showed that the maximum pressure is in the heel and metatarsal areas, and by performing optimizations, a proper distribution of plantar pressure was achieved. Optimization of the insole material resulted in a 40% reduction in maximum plantar pressure, and optimization of the medical insole shape resulted in a 55% reduction in maximum plantar pressure, which itself indicates a greater impact of optimizing the shape of the medical insole compared to its material.
خلاصه ماشینی:
Design and optimization of medical insoles in terms of shape and material: A finite element study Mehrdad Safdari Master of Science in Biomedical Engineering, Rehabilitation Engineering major, Islamic Azad University, Tehran Central Branch msafdari@yahoo.
The subject of this study is the design of a finite element model of the foot limb and the design and optimization of a medical insole model in order to achieve the best plantar pressure distribution and reduce maximum plantar pressure.
Materials and Methods In this article, a three-dimensional model of the foot and ankle was created to investigate foot mechanics, as well as to design and optimize a medical insole.
Steps of design, construction, and analysis of the foot model Imaging data collection, including CT scans of the foot and ankle of a person with diabetes, was performed, and models of the three-dimensional anatomy of the foot bones and soft tissues were created from these images.
This model is capable of predicting the plantar pressure distribution, maximum pressure values, and stresses in the soft tissue and orthopedic insole.
The optimization applied to change the shape of the orthopedic insole according to the longitudinal arch of the foot results in a 55 percent reduction in plantar pressure.
Additionally, optimization of the material of the orthopedic insole elements results in a 40 percent reduction in plantar pressure.
As the results show, changing the shape of the orthopedic insole according to the arch of the foot has a greater effect on reducing plantar pressure.